1.Zebra
Specifications/Special Features:

• Length L: <150.00mm±0.50, 150.00-200.00±0.65, 200.01-300.00mm±0.85
• Height H: 1.27-3.00mm±0.10, 3.01-5.00mm±0.15, 5.01-10.00mm±0.20
• Width W: 1.27-3.00mm±0.15, 3.01-5.00mm±0.20
• Width Wa: Standard 0.5mm±0.15 for YP, YS Types
• Conductor: Wc P x 0.5
• Insulator: Wi P x 0.5
• Pitch: P 0.25mm±0.8, 0.18mm±0.07, 0.10mm±0.07, 0.05mm±0.04
• Conductors/25.4: 100mm±15, 140mm±25, 250mm±40, 500mm±60
• Skew: <=3% of Connector Height
• Temperature/Humidity Range: -50°C to +200°C at 0 to 100% Humidity
• Breakdown Voltage: 25-27KV/mm
• Maximum Current: 1 mA/mm square
• Hardness (Shore A): 65N±10, 60N±10, 25N±5, 30N±5
• Compression Set (28°C @3000 Hrs): 12-18% of Compression Amount
• A wide range of rubber parts available

    

     2.Flexible
      Specifications/Special Features:

• Temperature: 115 to 140 degrees Celsius (surface of rubber)
• Pressure: 2.0 +/- 0.5 kgf/cm²
• Bonding time: 5 +/- 2 seconds
• Standard type heat seal connector consists of a polyester film as the base material, conductive carbon traces are printed onto the film
• The anisotropic adhesive layer is coated on top of the conductive traces for better insulation and conductivity, this adhesive layer
• is suitable for heat sealing to PCB and LCD
• Hot stamping condition
  • Temperature: 115 to 140 degrees celsius (surface of rubber)
  • Pressure: 2.0 + / - 0.5 kgf/cm²
  • Bonding time: 5 + / - 2 seconds
• Conductive: carbon, silver carbon
• Resistance: < / = 40 ohm, < / = 10 ohm
• Insulation resistance: >100m
• Peel strength:
  • X-Direction (paralell to traces) > / = 450 gf/cm
  • Y-Direction (perpendicular to trace) > / = 200 gf/3mm
  • Peeling angle: 90 degree
  • Peeling speed: 100 mm/min
  • Adhesion width: > / = 3mm